Manually configure your router to have a WAN address of whichever of the 5 usable Public IP addresses you've chosen, with a subnet mask of 255.255.255.248 and a default gateway of the router address for your subnet (the 6th one in the block) the Gateway will be listening on this address as a result of the Public Subnet setup. Do not play in the Cascaded Router section. So, set up the Public Static block in the Gateway (Public Subnet section of Home Network > Subnets & DHCP). But that's neither here nor there now you want to get a Public Static working. I have a BGW Gateway, with a router behind it, and a Plex server on that and it all works fine without double-NAT. Following the link, we suggest going to the paragraph titled Motorola NVG 510 and 589 and go through the steps located there. You should have been able to get rid of Double NAT without Public Static not sure why you didn't. When using an Arris NVG589 the settings for Configuring IP Passthrough and DMZplus are different than with other routers. But once you start mixing in the Public Static block into the picture, you usually want to turn it off, because it changes the LAN IP of the "cascaded" router to the Dynamic Public IP and that complicates your efforts (really prevents) you from setting it up with a Static Public IP. IF you're trying to pass your DYNAMIC Public IP address through, then IP Passthrough is the right thing to do. ![]() ![]() If I do add a second static IP device can I still run the 320 in IP passthrough or need to make any changes to it? My concern with a direct run to the 320 is that this port would then not have any firewall protection on it. But I'm thinking that I may need to connect this directly to the 320?Ĭan I just connect this to the switch and in the Synology just configure the gateway to be my AT&T gateway IP instead of the OPNsense box (which is what everything on my LAN uses)? My question is if I wanted my Synology (which runs my docker containers) to have the next static IP I was planning on assigned the IP to one of the spare network adapters on the unit and connecting that to my cisco switch (setting this up so that the traffic goes through the OPNsense. With the IP Passthrough OPNSense gets the first routable public IP of my /29 (that normally would be attached to the BGW-320). So due to issues I'm having with port forwarding to my Plex Media Server when using IP Passthrough I've decided to try assigning the container running PMS an AT&T provided static IP.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |